Table of Contents
Advertisement
40
FOLDING FRAME
for : THE ROYAL UF
FOLDING / UNFOLDING
Follow these simple steps to fold your electric bike :
STEP 1 (pedals)
Push the outside edge of the pedal towards the frame
and fold until the folding section is parallel to the frame
STEP 2 (handlebar and stem)
Release the 'safety catch' mechanism on the stem by
rotating clockwise or lifting the knob depending on which
version of the lock is on your bike. Open the quick release
lever by pulling away from the stem and lowering.
STEP 3
Fold handlebars to the side of the bike frame as shown
in the picture. (Pay attention not to force cabling. The
cables should fall in front or behind the stem when
folded, not forced over the folding mechanism.)
STEP 4 (frame)
Release the 'safety catch' mechanism located close
to the bottom bracket by lifting. Pull on the quick
release lever to unlock the frame hinge then push
the lever back towards the front of the frame to fully
clear the latch from the locking mechanism.
STEP 5
Lift the kickstand then rotate the front end of the
bike until the front and rear wheels are next to each
other. The bike can now be supported by the metal
stand situated under the bottom bracket.
To fold your electric bike repeat the steps in reverse order.
ADJUSTING THE HANDLEBAR POSITION
(FOLDING STEM)
You can adjust the height of the handlebar by opening
the quick release lever and lifting or lowering the
stem to the desired height. Once the height is set
close the quick release lever to lock the position.
ALWAYS MAKE SURE ALL SAFETY CATCHES ARE FULLY
ENGAGED BEFORE RIDING YOUR FOLDING ELECTRIC BIKE
STEM SAFETY CATCH
The stem safety catch is fully engaged
when turned counterclockwise, or the
knob is in the lowest position, and the
release lever cannot be opened.
DIAGRAM SHOWING FOLDING STEM
FRAME SAFETY CATCH
The frame safety catch is fully
engaged when rotated down and the
release leaver cannot be opened..
41
- Quick Links:
- Igo Drive
Hide quick links:
Advertisement
Table of Contents
