Adjustability And Igo Ergofit; Adjusting The Seat Height; Adjusting The Saddle Position; Adjusting The Handlebars (Quick Release) - Igo ASPIRE CAMILLIEN CE Owner's Manual

34
MECHANICAL COMPONENTS

ADJUSTABILITY AND iGO ERGOFIT

All iGO bikes are adjustable to suit individual riding position preferences.
iGO Bikes equipped with the Ergofit system have toolless adjustable reach, pitch
and height allows riding posture to be adapted instantly at any time for :
• Maximum comfort and minimized muscle fatigue during long rides
• Adaptable riding styles (e.g. upright relaxed leisure to low+forward power riding)
• Ergonomically fit different rider body types on the same bike

ADJUSTING THE SEAT HEIGHT

Your seat height should be adjusted properly to ensure you
get the most comfortable ride possible. The seat height
is properly adjusted when your knee has a slight bend
when sitting on the saddle with your foot on the pedal at
its lowest position. The seat height can be adjusted by
loosening the quick release lever on the seat tube clamp.
Retighten the quick release and check to make sure the
saddle is straight and held securely before riding again.

ADJUSTING THE SADDLE POSITION

You can tilt the saddle to change the seating angle, as well as adjust the fore/
aft position to suit your fit. To adjust the saddle, loosen the bolt located on the
underside of the seatpost clamp, under the saddle, with an Allen key. You will be
able to move the saddle back and forth, and change the angle to suit your preferred
riding style. When you are done adjusting, make sure to retighten the bolt.
Note:
Ensure that the safety marks for max. height (written on the seat post)
are not visible when the seat clamp is secured, and that the rails on the
saddle are clamped by the seatpost only on the straight section.
When the saddle has been adjusted to your satisfaction be sure the
nose is pointing straight ahead and is not twisted to either side.
DIAGRAM SHOWING SEAT CLAMP
for : DISCOVERY YORKVILLE LE | DISCOVERY ROSEMONT LE

ADJUSTING THE HANDLEBARS (QUICK RELEASE)

The adjustable stem has an effective quick-release mechanism that will allow
you to unlock, adjust and retighten the stem and handlebar position.
To use, find the lock button in the middle top of the stem and slide it forward to unlock
the main lever. While holding the button unlocked, lift the main lever fully up and rotate
towards the front of the bike. While fully opened, you will be able to adjust both the angle
of the stem and rotate the handlebars to achieve the most comfortable position.
When the handlebar is in the desired position, ensure it centered left and right in the
stem and close the main lever fully, ensuring you hear the lock button engage. Make sure
that the lock is engaged by pulling up on the main lever to verify that it does not open.
for : DISCOVERY YORKVILLE LS | DISCOVERY ROSEMONT LS | OUTLAND CABOT RS
OUTLAND SAWBACK RS | OUTLAND TORNGAT RS | ASPIRE CAMILLIEN CE | ASPIRE VENDOME CE

INSTALLING THE HANDLEBARS (4 BOLT STEM)

Using the 4mm Allen key take off the 4 front bolts of the stem and remove the front plate.
Place handlebar in position on stem, replace the front plate reinstall the 4 bolts loosely.
Tighten bolts as shown; make sure to attach all bolts one at a time in order from 1
to 4 but don't fully tighten until all bolts are installed. (tighten to 5Nm - 6Nm)
35