Disc Brake Alignment; How To Bed In New Disc Brake Pads; Adjusting Mechanical Disc Brakes Or Cable Actuated Hydraulic Brakes; Adjusting Hydraulic Disc Brakes - Igo ASPIRE CAMILLIEN CE Owner's Manual

32
MECHANICAL COMPONENTS

DISC BRAKE ALIGNMENT

Disc brakes provide increased stopping power to ensure safe control of electric bicycles.
To properly adjust disc brakes you must first make sure that the disc is properly aligned
within the brake caliper. To do this, loosen the top and bottom hex bolts with an Allen key.
Then manoeuvre the brake with your hand so that the disc
passes through the brake pads with minimal contact.
Once the disc rotates through the brake freely, retighten the hex bolts
and make sure that while tightening you maintain the alignment.
DIAGRAM SHOWING DISC BRAKE ALIGNMENT

HOW TO BED IN NEW DISC BRAKE PADS

Properly bedding in your brakes will increase the lifespan of the pads,
reduce noise and increase the braking power. Before your first ride, perform
this procedure to properly condition the brake pads and rotors :
1. Accelerate to a medium speed (approx. 20 km/h), then firmly apply the brakes
and reduce your speed to a walking pace. Repeat approximately 20 times.
2. Accelerate to a higher speed (approx. 32 km/h), then firmly and quickly apply the
brakes, reducing your speed to walking pace. Repeat approximately 10 times
3. Let the brakes cool before setting off on your first ride.
for : ASPIRE CAMILLIEN CE | THE ROYAL UF
ADJUSTING MECHANICAL DISC BRAKES OR
CABLE ACTUATED HYDRAULIC BRAKES
If squeezing the brake handle does not stop the bike
properly, you will have to adjust the brakes.
First try turning the barrel adjusters located on the brake caliper and brake lever counter
clockwise to increase the tension of the brake cable. If this still does not provide sufficient
stopping power when the brake lever is squeezed then it is recommended to check
the brake pads for wear and replace if necessary. If the pads are good and the brake
cable needs further adjustment, reset the barrel adjusters to their initial position then
proceed to loosen the hex bolt that retains the brake cable on the caliper with an Allen
key. Once the bolt is loosened, rotate the braking arm so that the brake is squeezing
the brake disc and spin the wheel. Move the brake arm back in small amounts until the
wheel is spinning smoothly. Pull the brake cable tight and retighten the hex bolt.

ADJUSTING HYDRAULIC DISC BRAKES

The hydraulic brake system on your iGO electric bike is self adjusting,
and will not require manual adjustment during normal operation.
If you pull the brake lever and the brakes fail stop your bike adequately, you
possibly have air in your brake line or the pads are worn past the usable limit.
In either case we strongly suggest this service be done by a professional
bike mechanic as special tools and procedures are required
33