Maintenance; Storage / Transport; Troubleshooting And Repaire - saro SB-K 130 Operating Instructions Manual

2. Be careful not to damage the connected cables.
3. Remove the visible dirt inside the unit manually with a hand brush or carefully with a
hoover. At best, dusty parts can also be cleaned with an air compressor.
4. Remove the dust filter and clean it of impurities. Especially here is the danger of a loss of
cooling due to contamination. The compressor would run hot and no longer provide the
desired cooling capacity. Allow the filter to dry in the air and then reinsert it. The
maintenance flap can now be closed again.

MAINTENANCE

The cooling unit requires very little maintenance. Check the ventilation slots for dirt once a month. Brush with a soft brush and at
the same time vacuum up the dirt with a vacuum cleaner.
Instructions as given above.
STORAGE / TRANSPORTATION
Remove all food, switch off the appliance, unplug the appliance.
Clean the appliance thoroughly inside and out and open the door to allow the appliance to dry sufficiently.
If it is dry and the unit is not to be used for a longer period of time, store it in a dry, dust-free and not hot place. It is best to cover
the unit or use the original packaging to protect the unit from damage.
Secure the unit against children and pets climbing into it, so that they cannot be trapped there.
When storing only the packaging material, please note that components of the packaging such as plastic bags, cardboard,
polystyrene parts, etc., can be dangerous for children if they play with them unsupervised (e.g. choking hazard). can endanger
children if they play with them unsupervised (e.g. choking hazard).
When transporting the unit, it is best to use the original packaging so that the unit is optimally protected against impact, sharp
edges, weather conditions, etc. Do not tilt the unit more than 45 degrees and do not expose it to moisture or rain and avoid
strong vibrations. After transport, the unit must stand for approx. 24 hours without further movement before it can be
reconnected. Otherwise, a defect may occur as the refrigerant and oil must be distributed/placed properly again.
TROUBLESHOOTING
Problem
No cooling
Unsatisfactory
performance
Strong noises
Stand 01/23 SvN
Cause and solution
Is the plug inserted? Is the socket in order? Is the fuse defective? Power failure? Thus
realise the power supply of the unit again.
cooling Direct sunlight? Is there a heat source nearby? Is the ventilation of the environment poor?
Does the door close properly? Is the door opened for a long time? Is the door sealing strip
deformed or damaged? Is there too much food inside? Is food blocking the air inlet or outlet?
Remedy this by readjusting the temperature controller.
Is the condenser clean?
The unit is not properly levelled.
The unit is touching the wall or other objects. Something is loose on the unit.
Correct the safe, straight stance and/or remove the touches.
Seite 22 von 25