Safety Notices - ATC G04 Series Installation, Operation & Service Manual

Applied Thermal Control Ltd
39 Hayhill Industrial Estate
Barrow-upon-Soar, Loughborough
LE12 8LD, United Kingdom
+44 (0) 1530 839 998
Service@thermalexchange.co.uk
Support@app-therm.com
1.1

SAFETY NOTICES

For your safety, we draw your attention to the following warning and caution marks
throughout the manual. Warning symbols can be found on the unit. Ensure you have read
through all warnings before starting the unit.
The safe operation of ATC products always remains the responsibility of the operator. This
equipment is intended to be used as a liquid temperature conditioning device – it requires no
external pump, nor any further manipulation of temperature. If the equipment is used in a
manner not specified by the manufacturer, the protection provided by the equipment may be
impaired. Failure to comply with a 'warning' may result in personal injury or death. ATC does
not accept any liability for injury caused through use of this equipment.
Caution: Failure to comply with a caution will invalidate product warranty and
absolve ATC from any liability, howsoever caused, and could result in permanent
damage to equipment.
Caution: Filling/topping up of the tank should only be undertaken with the unit
switched off, to prevent back-filling of the fluid.
Caution: This product contains no user-serviceable parts. Repair and service requires
specialized knowledge and tools to be provided by ATC or its local agent. Any
unauthorized tampering with the heat exchanger system automatically invalidates
warranty.
Warning: Hot and cold surfaces are present during operation. Take caution and care
when touching pump during operation.
Warning: Water pressures of up to 10 bar during operation.
Warning; Water and electricity near one another. Always ensure the unit is isolated
before service. The product is protected from overcurrent by fuses. Never bypass this
component.
During fault diagnostics and maintenance, it may be necessary to remove panels,
which expose the operator to the dangers of pressurized systems, hot or cold pipes
and electrical circuits. Only qualified personnel who are aware and equipped to deal
with these systems should only carry out such work.
Any temporary electrical supply to the chiller should be correctly earthed and
connected through an earth leakage trip.
In case of unexpected coolant leakage, safety glasses should always be worn when
the chiller is operated with the covers removed.
Under no circumstances leave the cooler unattended with the side panels removed.
Never alter settings of pressure switches, overloads, circuit breakers or any safety
device without first consulting Applied Thermal Control.
Installation, Operation & Service Manual
G04/K04
GENERAL SAFETY INFORMATION
Rev 1 – 05/04/23