Rimage Producer 7100 User Manual page 18

Rimage Producer 7100™ and Producer 8100™ User Guide
b. If the disc is not centered side to side
on the print pad, align the printer side
to side.
i. Loosen the side to side screws.
ii. Slide the printer, not the printer
tray, until the side edges of the
disc and print pad are aligned.
iii. Tighten the side to side screws.
c. Using either the T25 Torx driver or the
5/32" Allen wrench, turn the front to
back alignment screw until the disc
hangs over the edge of the print pad
by 0.010" - 0.015" (0.25mm -
0.38mm).
5. Raise the lift arm to the top of the unit.
6. To close the printer tray, press the printer button.
7. To release the disc from the gripper, press the disc release button.
Tip: Place your hand under the disc to catch it.
8. Close the door.
12
Print Pad
Side to Side Screws
Front to Back
Alignment Screw
110867_A