Rimage Producer 7100 User Manual page 16

Rimage Producer 7100™ and Producer 8100™ User Guide
5. Align the printer.
a. Slowly move the lift arm down until the disc touches the recessed print pad.
Printer
Button
Side to Side
Alignment
Print
Pad
b. If the disc is not centered side to side on the print pad, align the printer side to side.
i. Loosen the side to side screws.
ii. Slide the printer, not the printer
tray, until the disc is centered side
to side on the print pad.
iii. Tighten the side to side screws.
c. Using either the T25 Torx driver or the
5/32" Allen wrench, turn the front to
back alignment screw until there is a
1/16" (1.5mm) gap between the front
edge of the disc and the raised edge of
the disc retainer.
6. Raise the lift arm out of the way of the print tray.
7. To close the printer tray, press the printer button.
8. To release the disc from the gripper, press the disc release button.
Tip: Place your hand under the disc to catch it.
9. Close the door.
10
Disc
Retainer
Lift
Arm
Holding Pins
Side to Side Screws
Front to Back Screw
110867_A
Gap