Trailering - TOHATSU M 6B Owner's Manual

ENON00021-3
Note
If the outboard motor must be laid down,
be sure that fuel is completely drained,
then lay the outboard motor with port side
down on the cushion as shown in the
drawing.
ENOM00072-A

3. Trailering

ENOW00072-0
CAUTION
Trailering in the tilted position may cause
damage to the outboard motor, boat, etc.
ENOW00073-A
WARNING
Be sure to disconnect fuel connector except
when operating engine.
REMOVING AND CARRYING THE OUTBOARD MOTOR
Fuel leakage is a fire or explosion hazard,
which can cause serious injury or death.
ENOW00068-0
Close air vent screw of fuel tank and fuel
cock before carrying or storing outboard
motor and fuel tank, or fuel may leak, poten-
ENOF02232-0
tially catching fire.
ENOW00071-0
The tilt support device supplied on your out-
board motor is not intended for towing. It is
intended to support the outboard motor
while the boat is docked, beached, etc.
When transporting a boat on a trailer
with the outboard motor still attached,
disconnect the fuel line from the out-
board motor beforehand and keep the
ENOF02233-0
outboard motor in the normal running
position or on a transom saver bar.
Tiller handle type
While transpor ting outboard motor
attached to the boat on a trailer, properly
tighten the steering friction bolt to pre-
vent the outboard motor from moving
(page 45).
ENOF00075-1
WARNING
CAUTION
43
8