Table of Contents
Advertisement
Link to Mobile
Link to mobile feature
You can connect your base unit and mobile
phone using Bluetooth wireless technology, so
that you can make or answer mobile calls
using your phone system. This allows you to:
– use the unit to talk on mobile calls even if
some areas of your home have poor mobile
reception, simply by placing your mobile
phone in an area with good reception.
– talk on mobile calls even if your mobile
phone is in your pocket or bag.
– enjoy cordless mobile calls even if your
mobile phone plugged in and charging.
Important:
R Your mobile phone must support the Hands
Free Profile (HFP) specification.
R You may pair 2 mobile phones and 1
headset.
R The unit can be used to talk on 2 lines at
the same time (for example, 2 mobile lines,
or the landline and 1 mobile line).
R Only 2 Bluetooth devices can be used with
the unit at the same time (for example, 2
mobile lines, or the headset and 1 mobile
line).
R Locate your mobile phone near the base
unit. If the mobile phone is too close to the
base unit during a mobile call, you may
hear noise. For best performance, we
recommend placing the mobile phone
between 0.6 m to 3 m away from the base
unit.
Pairing a mobile phone
Important:
R Before pairing a Bluetooth enabled mobile
phone to the base unit, make sure that no
other Bluetooth device such as a Bluetooth
headset is connected to your mobile phone.
1
Base unit:
Press and hold MMOBILE 1N or
MMOBILE 2N for a few seconds.
R After the corresponding MOBILE
indicator on the base unit starts
flashing, the rest of the procedure
must be completed within 5 minutes.
16
2
Your mobile phone:
While the corresponding MOBILE
indicator is flashing, follow the
instructions of your mobile phone to
enter the pairing mode.
R Depending on your mobile phone, it
may ask you to enter the Bluetooth
PIN (default: "0000"). If your
mobile phone shows PassKey
confirmation on its display, follow
the directions to proceed.
3
Base unit:
Wait until a long beep sounds.
R It may take more than 10 seconds
to complete pairing.
R When the corresponding MOBILE
indicator lights up, the mobile phone
is connected to the base unit. You
are ready to make mobile calls.
4
MEXITN
Note:
R Make sure that your mobile phone is set
to connect to this product automatically.
Refer to your mobile phone's operating
instructions.
R Make sure you cancel your mobile
phone's current pairing if you want to
pair it to the other line (page 16).
R The default setting for the alert feature is
"On", so when you pair your mobile
phone to the base unit, this feature may
be activated (page 59). (This depends
on the version and type of mobile phone
you are using.)
Unpairing a mobile phone
You can cancel the pairing of a mobile phone
that is stored in the base unit.
Handset
1
For MOBILE 1: MMENUN#6111
For MOBILE 2: MMENUN#6112
2
MbN: "Yes" a MSELECTN
R When the mobile phone is unpaired,
the MOBILE indicator is turned off.
3
MOFFN
Advertisement
Table of Contents
