Table of Contents
Advertisement
*3
When the mobile line only mode is turned on, these menus are not displayed (page 18).
*4
After the Bluetooth device is paired, the device name is displayed.
*5
For MOBILE 1
*6
For MOBILE 2
*7
The preset melodies in this product ("Tone 3" - "Melody 10") are used with permission of
© 2009 Copyrights Vision Inc.
*8
The preset melodies in this product ("Tone 1" and "Tone 2") are used with permission of
© 2013 Copyrights Vision Inc.
*9
This feature allows the unit to automatically adjust the date and time each time caller
information including date and time is received.
To turn this feature on, select "Caller ID auto". To turn this feature off, select
"Manual". (Caller ID subscribers only)
To use this feature, set the date and time first (page 15).
*10 If you subscribe to a distinctive ring service, select a tone. If you select a melody, you cannot
distinguish lines by their ringers.
*11 This tone lets you know when you receive an outside call while you are on another line or an
intercom call. If you select "On", the tone sounds 2 times.
*12 This setting is available when you have the key finder (KX-TGA20AZ). Read the installation
manual for more information on the key finder.
*13 For models with supplied key finders, the display shows "1: Finder1".
*14 If you register 2 or more key finders.
*15 If you subscribe to a Caller ID service and want to view the caller's information after lifting up
the handset to answer a call, turn off this feature.
*16 The recall time depends on your telephone exchange or host PBX. Contact your PBX
supplier if necessary.
*17 The default setting will be as follows if you select the following regional code when changing
the unit's region setting (page 51):
"NewZealand" = "600 ms"
*18 Generally, the line mode setting should not be changed. This setting automatically maintains
receiver volume at the proper level depending on the current telephone line condition. Set
the line mode to "A" if telephone line condition is not good.
*19 This setting is available when a mobile phone is paired.
Alarm
An alarm sounds at the set time for 1 minute
and is repeated 5 times at 5 minute intervals
(snooze function). A text memo can also be
displayed for the alarm. A total of 3 separate
alarm times can be programmed for each
handset. You can set one of 3 different alarm
options (once, daily, or weekly) for each alarm
time.
Important:
R Make sure the unit's date and time setting
is correct (page 15).
Handset
1
MMENUN#720
2
MbN: Select the desired alarm. a
MSELECTN
3
MbN: Select the desired alarm option. a
MSELECTN
"Off"
Turns alarm off. Go to step 10.
"Once"
An alarm sounds once at the set time.
"Daily"
An alarm sounds daily at the set time.
Go to step 5.
Programming
47
Advertisement
Table of Contents
