Table of Contents
Advertisement
Link to mobile settings
Selecting which unit receives
mobile calls
You can select which unit rings and receives
calls for a mobile line. When "All" is
selected, all handsets and the base unit ring.
Handset
1
For MOBILE 1: MMENUN#6271
For MOBILE 2: MMENUN#6272
2
MbN: Select the desired handset or "All".
a MSAVEN
3
MOFFN
Note:
R When you select a specific handset to
receive calls for a mobile line:
– other handsets cannot answer the calls.
– the base unit can answer the calls even
though it does not ring. However, you
can make the base unit ring by adjusting
the base unit ringer volume (page 46).
R When you change to "All" from another
setting, the base unit ringer volume also
returns to the lowest level even if the ringer
volume was changed.
R The units selected with this setting have the
alert feature (page 59) applied to them.
Ring as mobile mode
Once this feature is turned on, the handset
and base unit ring using the same ringer tone
as your mobile phone.
The following settings are available:
– "Off": Turn this feature off to use the
ringer tones of the handset and base unit.
Caller information is announced depending
on the Talking Caller ID setting (page 43).
– "On (with Talking CID)" (default):
The handset and base unit use your mobile
phone's ringer tone. Caller information is
announced even if the Talking Caller ID is
turned off.
– "On (without Talking CID)": The
handset and base unit use your mobile
phone's ringer tone. Caller information is
not announced even if the Talking Caller ID
is turned on.
Important:
R To use this feature, your mobile phone
must support Bluetooth in-band ringtone.
Refer to your mobile phone's operating
instructions.
Handset
1
For MOBILE 1: MMENUN#6141
For MOBILE 2: MMENUN#6142
2
MbN: Select the desired setting.
3
MSAVEN a MOFFN
Note:
R The units use the preset ringer tones
instead of your mobile phone's ringer tone
when a mobile call is being received if:
– your mobile phone is in do not disturb
mode (depending on your mobile phone).
– the base unit is in use.
– 2 handsets are sharing a landline call.
R If your mobile phone is in do not disturb
mode with "On (with Talking CID)"
set, the unit announces caller information
even when Talking Caller ID is turned off
(page 43).
To use the handset ringer tone
instead of your mobile phone's ringer
tone
Select "Off" in step 2, "Ring as mobile
mode", page 17.
To change the handset ringer tone for a
mobile line, see page 41.
Auto connection to the Bluetooth
devices (mobile phones)
After pairing, your Bluetooth devices are
connected to the base unit. If you move the
Bluetooth devices out of base unit range, the
Bluetooth devices are disconnected from the
base unit. This feature allows the base unit to
try to reconnect the Bluetooth devices at
regular intervals when it returns within base
unit range. You can set the interval. The
default setting is "1 min".
Link to Mobile
17
Advertisement
Table of Contents
