Table of Contents
Advertisement
Figure 157. Installing Tower Rigging System Plate
to LCC44
• Using a 4 mm hex key (Allen type) with a length that allows
for sufficient leverage, tighten the screws into the inserts in
opposing pairs to firmly attach the rigging plate to the CSUB610.
The plate should be perfectly flush with the cabinet at every
point and there should be no movement possible.
If the LCC44 or LCC84 unit is being deployed as a single unit in a
sub/satellite configuration atop a subwoofer using a Tower Tube Mount
equipped with a rigging plate, or as a single unit (with no further
enclosures above it) directly atop a subwoofer equipped with a rigging
plate, it is not necessary to mount the second rigging plate on the top
of the enclosure.
• If, instead, the LCC44 or LCC84 unit is to be used with further
units installed above it in a stacked configuration, it will be
necessary to install the second rigging plate. If necessary, invert
the LCC44/84 unit and repeat Steps 2 though 6 above.
Coupling LCC44/84 to SUB310 using Tower Rigging
System
Once a SUB310 has been equipped with outriggers and leveled and
a Tower Rigging System plate has been properly installed, it can be
coupled in stacked configuration with a single unit of LCC84 (or a single
LCC44) likewise equipped with a rigging plate.
Tipping Hazard
Improper installation of the Subwoofer Outriggers or
the Tower Rigging System plate on a subwoofer
enclosure, or of the rigging plate on the LCC44 or
LCC84 unit could create a hazardous or unstable
condition when the subwoofer and column enclosure
are assembled.
Follow all specific instructions for the assembly
of each of these products and verify their stable
and level condition before attempting to mount
a speaker enclosure atop any of them. DO
NOT ATTEMPT TO MOVE OR REPOSITION A
SUB/SATELLLITE ASSEMBLY OR STACKED AND
COUPLED SPEAKER ARRAY.
| 8 - STACKING LCC84/LCC44 ON SUB310 USING THE TOWER RIGGING SYSTEM
WARNING
WARNING
Tipping Hazard
The SUB310 model subwoofer is designed for use in a
stacked and coupled configuration with a maximum of
one (1) LCC84 unit, or one (1) LCC44 unit. Mounting
further enclosures atop the SUB310 will render the
entire assembly unstable.
DO NOT ATTEMPT to mount a second LCC84 or
LCC44 enclosure atop the assembled array of SUB310
and LCC44/84.
WARNING
Risk of Hand Injury
When coupling or setting the splay angle between two
LCC44/84 units or a subwoofer unit and an LCC44/84
unit, do not allow your fingers to enter the space
between the two rigging plates or any of the holes.
Figure 158. Placing LCC84 atop SUB310 for
coupling.
Advertisement
Table of Contents
