Mounting Lcc44 On Active Speaker Tube Using The Tower Tube Mount - 1 Sound LCC44 Manual

STACKED AND POLE-MOUNTED DEPLOYMENTS OF THE TOWER SYSTEM
Important: For permanent or semi-permanent installation of the
Tower Tube Mount on the LCC44 enclosure, the use of medium-
strength threadlocking compound is recommended on all user-
installed screws.
Figure 132. Mounting Tower Tube Mount to bottom
of LCC44
• Using a 4 mm hex driver, tighten the two screws very firmly.
Mounting LCC44 on Active Speaker Tube using the Tower
Tube Mount
Once the Tower Tube Mount has been correctly installed directly on
an LCC44 enclosure, the enclosure can then be very simply mounted
on an Active Speaker Tube, either atop a subwoofer in a sub/satellite
configuration, or independently atop an Active Speaker Tube with base.
Tipping Hazard
Improper assembly of the Active Speaker Tube with
Base or improper installation of the Active Speaker
Tube, Sub Pole Cup, or Subwoofer Outriggers on a
subwoofer enclosure, or of the Tower Tube Mount
on the LCC44 could create a hazardous or unstable
condition when the LCC44 is mounted atop them.
Follow all specific instructions for the assembly of
each of these products and verify their stable and
level condition before attempting to mount a speaker
enclosure atop any of them. DO NOT ATTEMPT
TO MOVE OR REPOSITION A SUB/SATELLLITE
ASSEMBLY OR A FREE-STANDING SPEAKER
STAND WITH AN ENCLOSURE MOUNTED ATOP IT.
WARNING
WARNING
Tipping Hazard
DO NOT USE THE TOWER RIGGING SYSTEM
PLATES TOGETHER WITH THE TOWER TUBE
MOUNT AND SPEAKER TUBES FOR SUBWOOFER/
SATELLITE CONFIGURATIONS ATOP THE SUB12
OR CSUB210 MODELS OR WITH THE ACTIVE
SPEAKER TUBE WITH BASE.
The use of pole mounted configurations of the LCC44
model enclosure with the inclinable Tower Rigging
System plates is possible only atop the CSUB610 or
SUB310 model subwoofers.
• Make sure that the 95 cm Active Speaker Tube is properly
installed in the CSUB610 or SUB310 (either model equipped
with Outriggers and properly leveled and positioned for use) or
that the free-standing 175 cm Active Speaker Tube and Base
is safely positioned. Then simply lift the LCC44 with the Tower
Tube Mount above the Active Speaker Tube and align it in the
desired direction. Though not obligatory, this will generally be
with the rear of the LCC44 towards the rear of the subwoofer,
where the connectors are located.