Mounting Lcc44 On Active Speaker Tube Using The Tower Rigging System - 1 Sound LCC44 Manual

STACKED AND POLE-MOUNTED DEPLOYMENTS OF THE TOWER SYSTEM
Figure 57. Setting tilt angle with the Tower Tube
Mount configured for -3°, -6° and -9°.
Figure 58. Fixing tilt angle of Tower Rigging System
and Tower Tube Mount (-3° shown)
• When the required holes are perfectly aligned, take the other
M10×100 ball-lock pin supplied with the rigging plates and
press the lock-release button on the rear of the pin to allow
it to pass into the hole. Insert it into the holes, pushing it
completely through all four aligned holes until the ball-lock
emerges from the far side. When it emerges, release the button
to allow the lock to engage and assure that the pin cannot be
removed without again pressing the release. The enclosure is
now coupled at the proper angle to the mounting assembly and
ready to mount on an Active Speaker Tube.
Mounting LCC44 on Active Speaker Tube using the Tower
Rigging System
Once the Tower Tube Mount has been correctly assembled with a
Rigging Plate, coupled with an LCC44 enclosure likewise equipped with
a rigging plate and the tilt angle has been fixed, the enclosure can then be
very simply mounted on an Active Speaker Tube, either atop a CSUB610
or SUB310 subwoofer in a sub/satellite configuration, or independently
atop an Active Speaker Tube with base.
WARNING
Tipping Hazard
Improper assembly of the Active Speaker Tube with
Base or improper installation of the Active Speaker
Tube, Sub Pole Cup, or Subwoofer Outriggers on a
subwoofer enclosure, or of the Tower Tube Mount
on the LCC44 could create a hazardous or unstable
condition when the LCC44 is mounted atop them.
Follow all specific instructions for the assembly of
each of these products and verify their stable and
level condition before attempting to mount a speaker
enclosure atop any of them. DO NOT ATTEMPT
TO MOVE OR REPOSITION A SUB/SATELLLITE
ASSEMBLY OR A FREE-STANDING SPEAKER
STAND WITH AN ENCLOSURE MOUNTED ATOP IT.
WARNING
Tipping Hazard
DO NOT USE THE TOWER RIGGING SYSTEM
PLATES TOGETHER WITH THE TOWER TUBE
MOUNT AND SPEAKER TUBES FOR SUBWOOFER/
SATELLITE CONFIGURATIONS ATOP THE SUB12
OR CSUB210 MODELS OR WITH THE ACTIVE
SPEAKER TUBE WITH BASE.
The use of pole mounted configurations of the LCC44
model enclosure with the inclinable Tower Rigging
System plates is possible only atop the CSUB610 or
SUB310 model subwoofers.
• Make sure that the 95 cm Active Speaker Tube is properly
installed in the CSUB610 or SUB310 (either model equipped
with Outriggers and properly leveled and positioned for use) or
that the free-standing 175 cm Active Speaker Tube and Base
is safely positioned. Then simply lift the LCC44 with the Tower
Tube Mount above the Speaker Tube and align it in the desired
direction. Though not obligatory, this will generally be with the
rear of the LCC44 towards the rear of the subwoofer, where the
connectors are located.