Installing Outriggers On The Sub310 - 1 Sound LCC44 Manual

Stacked and pole-mounted deployments of the tower system
Hide thumbs Also See for LCC44:
Table of Contents

Advertisement

Figure 69. Installing the rubber feet on the SUB310.
• The cabinet can now be raised to the upright position, this time
with the cover plate for the Sub Pole Cup mount on the top.
• To install the Sub Pole Cup, first use a 4 mm hex wrench to
remove the four M6×20 mm countersunk screws that hold the
cover plate in place. When these are removed, remove the
cover plate as well and put it aside.
Figure 70. Removing the cover plate for Sub Pole
Cup installation.
• Insert the Sub Pole Cup flange into the recess in the cabinet
and seat it firmly.
Figure 71. Installing the Sub Pole Cup on SUB310
| 5 - DEPLOYING LCC44 ON ACTIVE SPEAKER TUBE ATOP SUB310
• Re-insert the screws that retained the plate into the four
countersunk holes in the Sub Pole Cup, and thread them into
the inserts below the cup.
Figure 72. Tightening the screws holding the Sub
Pole Cup.
• Again, using the 4 mm hex wrench, tighten the four screws
firmly.

Installing Outriggers on the SUB310

Installing the subwoofer outriggers improves the stability of the CSUB610
or SUB310 when deployed vertically on the floor. The outriggers are
recommended in any application in which the subs are deployed in
public areas where people could bump into them or lean on them.
These are also REQUIRED in any application in which other loudspeaker
enclosures are coupled to the subwoofer in an upright position.
TIPPING HAZARD
Speaker enclosures stacked atop one another, even
when properly coupled, represent a tipping hazard.
TO
REDUCE
DAMAGE THAT COULD RESULT FROM POSSIBLE
TOPPLING OF LOUDSPEAKER ENCLOSURES,
THE
INSTALLATION
OUTRIGGERS ON THE SUB310 AND CSUB610
IS REQUIRED WHENEVER ONE OR MORE
LOUDSPEAKER
ATOP ONE OF THESE UNITS, EITHER IN A
STACKED CONFIGURATION USING THE TOWER
RIGGING SYSTEM OR IN A SUB/SATELLITE
CONFIGURATION USING A SPEAKER POLE.
Figure 73. Raising the leveling feet of the
Outriggers.
• Before installation, on each of the four Outriggers, raise the
leveling feet by screwing them in completely.
WARNING
THE
RISK
OF
INJURY
OF
THE
SUBWOOFER
ENCLOSURES
IS
MOUNTED
OR

Advertisement

Table of Contents
loading

Related Products for 1 Sound LCC44

This manual is also suitable for:

Lcc84Sub310Sub610Csub210Sub12

Table of Contents