Table of Contents
Advertisement
Chapter 4. Deploying LCC44 on
an Active Speaker Tube atop
CSUB610
Figure 25. LCC44 deployed atop CSUB610 using the
95 cm Active Speaker Tube and Tower Tube Mount.
Critical information
Attention: This equipment is intended for installation by qualified
professionals.
Notice: Please read these instructions carefully and completely
before attempting deployment of speaker enclosures on floor
stands.
Tipping Hazard
Speaker enclosures stacked atop one another, even
when properly coupled, represent a tipping hazard.
Exercise extreme care when assembling speaker
arrays, as a stack of them toppling or collapsing
creates a risk of serious injury or death, as well as likely
damage to the enclosures themselves and nearby
equipment.
Notice: This product must be installed in compliance with all
applicable local, state and national regulatory provisions. The
responsibility rests with the installer to verify that the installation
is carried out in accordance with any applicable legislation.
Important: The installer must assess the appropriate stability
and sturdiness of the deployment surface.
Restriction: Only hardware and accessories included with
the product or specified by 1 Sound should be used for its
installation.
Restriction: Do not modify or alter the loudspeaker or any
accessory. Any modification by the user or installer could render
the product or the installation unsafe.
Restriction: Do not install a loudspeaker or any accessory near
any open flame or heat source.
Products, accessories and tools required
To deploy an LCC44 enclosure as a satellite on a CSUB610 bass unit
using an Active Speaker Tube you will need the following:
•
An
LCC44 (on page 4)
•
A
CSUB610 (on page 5)
•
The
Sub Pole Cup (on page 8)
•
The
Subwoofer Outrigger (on page 9)
•
The 95 cm
Active Speaker Tube (on page 7)
Passive Speaker Tube (on page 7)
•
The
Tower Tube Mount (on page 7)
•
A 5 mm Allen wrench
•
A 4 mm hex driver at least 10 cm long, preferably magnetized
•
A 4 mm Allen wrench
•
Threadlocking compound
•
Optional:
Tower Rigging System Plates (on page 8)
•
Recommended: Spirit level
WARNING
loudspeaker enclosure
subwoofer enclosure
adapter flange kit
stabilizing leg kit
or the
adapter kit
40 cm
Advertisement
Table of Contents
