Table of Contents
Advertisement
STACKED AND POLE-MOUNTED DEPLOYMENTS OF THE TOWER SYSTEM
Figure 39. CSUB610 front-to-back leveling.
• Once the subwoofer has been leveled side-to-side, place the
spirit level across the top surface of the subwoofer cabinet,
perpendicular to the front grille of the enclosure, again avoiding
placing it on non-flush elements, such as the Sub Pole Cup.
• Read the level, and if the Subwoofer is slightly out of level front-
to-back, adjust the feet of the pair of Outriggers on the side
(front or back) that is lower, using the same procedure in Step
3 above. Again, this may need to be repeated several times to
achieve correct leveling.
• Once the subwoofer unit has been leveled both side-to-side and
front-to-back, check again the leveling on both axes, making
any slight adjustments necessary until the cabinet is level both
side-to-side and front-to-back.
Installing Active Speaker Tube to CSUB610
In order to deploy an LCC44 unit in a sub/satellite configuration atop
a CSUB610 or SUB310 unit with the Sub Pole Cup installed, it is only
necessary to insert the Active Speaker Tube into Pole Cup with the
SpeakOn connectors facing the rear of the subwoofer cabinet and assure
that it is firmly seated in the Pole Cup. For special applications, in order
to meet the requirements of the audience's listening height, the 40 cm
Speaker Tube can be used in the place of the 95 cm model in this
configuration.
TIPPING HAZARD
DO NOT USE THE 145 cm ACTIVE SPEAKER TUBE
TO MOUNT AN LCC44 UNIT ATOP THE CSUB610
OR SUB310 SUBWOOFER
TO
REDUCE
DAMAGE THAT COULD RESULT FROM POSSIBLE
TOPPLING OF LOUDSPEAKER ENCLOSURES,
ONLY THE 95 cm ACTIVE SPEAKER TUBE OR
40 cm SPEAKER TUBE TO MOUNT ENCLOSURES
IN SUB/SATELLITE CONFIGURATIONS ATOP THE
CSUB610 OR SUB310 SUBWOOFER MODELS.
WARNING
THE
RISK
OF
INJURY
Figure 40. Installing the 95 cm Active Speaker Tube
on the CSUB610.
• Align the 95 cm Active Speaker Tube with the Sub Pole
Cup installed in the subwoofer, with the SpeakOn connectors
oriented toward the rear of the subwoofer cabinet (where the
connectors are located).
Figure 41. Active Speaker Tube installed in
CSUB610.
OR
• Lower the Active Speaker Tube to slide into the Sub Pole Cup,
making sure that it does not catch or bind as it enters. It should
stop firmly when the Tube arrives at the threaded M20 insert at
the bottom of the Pole Cup. The bottom SpeakOn connector of
the Speaker Tube should come to a stop at 1 cm above the top
of the Sub Pole Cup.
Advertisement
Table of Contents
