Table of Contents
Advertisement
Chapter 3. Deploying LCC44 on an
Active Speaker Tube & Base
Figure 14. LCC44 deployed on the Active Speaker
Tube and base.
Critical information
Attention: This equipment is intended for installation by qualified
professionals.
Notice: Please read these instructions carefully and completely
before attempting deployment of speaker enclosures on floor
stands.
Tipping Hazard
Speaker enclosures mounted on poles or stands
represent a tipping hazard.
Exercise care when deploying speaker enclosures on
poles or stands. In the case of mechanical failure or
accidental tipping, there is a risk of serious injury or
even death, as well as likely damage to the enclosures
themselves and nearby equipment.
Tipping Hazard
DO NOT MOUNT THE MODEL LCC84 SPEAKER
ENCLOSURE ON THE ACTIVE SPEAKER TUBE
WITH BASE
The Active Speaker Tube with Base is designed only
for the safe deployment of the LCC44 unit using the
Tower Tube Mount, without the Tower Rigging System
plates.
Tripping/Falling Hazard
Speaker enclosures mounted on poles or stands
represent a tripping hazard.
Exercise care when deploying speaker enclosures
on poles or floor stands. Free-standing loudspeaker
supports and accompanying cables should be
positioned at a safe distance from walkways, trafficked
areas and the general public to minimize risk of injury or
damage to the enclosures themselves and associated
equipment.
Notice: This product must be installed in compliance with all
applicable local, state and national regulatory provisions. The
responsibility rests with the installer to verify that the installation
is carried out in accordance with any applicable legislation.
Important: The installer must assess the appropriate stability
and sturdiness of the deployment surface.
Restriction: Only hardware and accessories included with
the product or specified by 1 Sound should be used for its
installation.
Restriction: Do not modify or alter the loudspeaker or any
accessory. Any modification by the user or installer could render
the product or the installation unsafe.
Restriction: Do not install a loudspeaker or any accessory near
any open flame or heat source.
Products/accessories involved
To deploy an LCC44 enclosure on an Active Speaker Tube with Base
you will need the following:
•
An
LCC44 (on page 4)
•
The
Active Speaker Tube & Base (on page
•
The
Tower Tube Mount (on page 7)
•
Optional:
Tower Rigging System Plates (on page 8)
Procedures
Assembling Active Speaker Tube with Base
The 175 cm Active Speaker Tube and base can be used to deploy a
single, freestanding LCC44 unit. The stand and base must be properly
assembled prior to coupling with the speaker enclosure.
WARNING
WARNING
CAUTION
loudspeaker enclosure
8)speaker stand kit
adapter kit
Advertisement
Table of Contents
