Installing The Tower Tube Mount On A Tower Rigging System Plate - 1 Sound LCC44 Manual

• Lower the LCC44 enclosure and allow the Active Speaker Tube
to slide into the Tower Tube Mount, making sure that it does not
catch or bind as it enters. It should stop firmly when the Tube
arrives at the top of the Mount, with the bottom of the Tower
Tube Mount coming to 2 cm above the top SpeakOn connector.
Figure 47. LCC44 with Tower Tube Mount installed
on Active Speaker Tube.
• Physically assure the stability of the installation and that it will
not tip using mild force applied in any direction at the highest
point of the assembly.
Installing the Tower Tube Mount on a Tower Rigging
System Plate
When the application requires that the LCC44/84 unit be adjustable in
tilt with respect to the floor, the Tower Tube Mount can be attached to a
Tower Rigging System rigging plate to allow different tilt angles. There
are two configurations possible for using the Tower Tube Mount with the
Tower Rigging System rigging plate: one that allows the coupled satellite
enclosure to be tilted -3°, 0° or +3° with respect to the floor, and another
that allows only downward angles of -3°, -6° and -9°.
To attach the Tower Tube Mount to a Tower Rigging System rigging
plate:
• Lay the Tower Rigging System plate flat with the uniform
surface up.
Figure 48. Mounting holes for Tower Tube Mount on
the Tower Rigging System plate.
• Position the Tower Tube Mount upside-down, with the open
side up and the countersunk-drilled plate against the bottom of
the rigging plate, in one of the two positions shown in the figures,
depending on the coverage required.
• Align the two countersunk holes in the Tower Tube Mount with
the threaded holes in the plate shown in the figures, making
sure to achieve the desired tilt angle possibilities.
| 4 - DEPLOYING LCC44 ON AN ACTIVE SPEAKER TUBE ATOP CSUB610
Figure 49. Tower Tube Mount on Rigging plate for
0°, -3° and +3° tilt.
Figure 50. Tower Tube Mount on Rigging plate for
-3°, -6° and -9° tilt.
• Carefully thread the two M6 x 12 mm screws supplied with the
Tower Tube Mount into the inserts through the holes in the
Mount. A magnetized hex driver can facilitate this.
Important: For permanent or semi-permanent installation of the
Tower Tube Mount on the LCC44 enclosure, the use of medium-
strength threadlocking compound is recommended on all user-
installed screws.