Ecco Vantage 12+ Series Installation & Operation Instructions page 8

Gutter Mounting
Important!
Mounting brackets are specific to the vehicle model. Please make sure the brackets are suitable for the vehicle before
installation.
1. Remove mounting foot. Position bracket onto nubs of the foot.
2. Holding the bracket and foot together, insert the cage nut as shown. It will fit snugly underneath the mounting foot. Do not install it on
the outside face.
3. Install the mounting feet in reverse order of their removal. The metal bracket will be sandwiched between the bar and the composite
mounting foot. Adjust the spacing of the mounting feet before securely tightening the nuts.
4. Hand thread the M6 bolt through the star washer and mounting strap into the cage nut. Be careful not to cross thread the bolt, and
leave loose until later steps.
5. Once the bar is in position, use the strap as a template to drill Ø1/8" holes for screws, or Ø3/16" hole for rivets. It may be necessary to
pull back the door sealing gasket or trim. Apply silicone or sealant around the hole, behind the strap. Secure the straps with the pro
vided #10 stainless steel sheet metal screws with washers as shown. Screws should be tightened around 5-10 in-lb.
6. Tighten the M6 bolts evenly so that the bar is even and centered. Reinstall any removed trim and/or weather-stripping and close doors
to check secure fit of the lightbar.
M6 SCREW
MOUNTING
STRAP
#10 STAR WASHERS
SHEET METAL SCREWS
LIGHTBAR
MOUNTING FOOT
M6 STAR WASHER
Ø1/8" HOLES
12+ Series Roof Mounting Kits
(Please call Customer Service for more options)
Vehicle
FORD,TRUCK,SUPERDUTY,'17
FORD,TRUCK,F150,'15-'17
DODGE,TRUCK,1500,'09-'17
CHEVY/GM,TRUCK,1500,2500,3500,'14-'17
GM,TAHOE/YUKON,'14-'17
TOYOTA,TACOMA,'05-'17
TOYOTA,TUNDRA,'15-'17
HEADACHE RACK MOUNTING BRACKETS
5/16" HEX BOLTS
5/16" SPLIT LOCK WASHERS
VEHICLE ROOF
P/N
A1234RMK
A1234RMK
A1236RMK
A1237RMK
A1237RMK
A1238RMK
A1239RMK
A1032RMK
FOOT BRACKET
M6 CAGE NUT
5/16" FLAT WASHERS
5/16" HEX NUTS