Ecco 12+ Series Mounting Instructions

IMPORTANT!
Read all instructions before installing and using. Installer: This manual must be
delivered to the end user. This manual assumes installation by a suitably qualified Automotive Technician.
!
WARNING!
Failure to install or use this product according to manufacturer's recommendations may result in property
damage, serious bodily/personal injury, and/or death to you and those you are seeking to protect!
Important!
Mounting brackets are specific to the vehicle model. Please make sure the brackets are suitable for the vehicle before
installation.
12 + Series Lightbar Roof Mounting Kits
1. Remove mounting foot. Position bracket onto knubs of the foot.
2. Holding the bracket and foot together, insert the cage nut as shown. The fit will be snug under the mounting foot. Do not install it on the
outside face.
3. Install the mounting feet in reverse order of their removal. The metal bracket will be sandwiched between the lightbar and the composite
mounting foot. Adjust the spacing of the mounting feet before securely tightening the nuts.
4. Hand thread the M6 bolt through the star washer and mounting strap into the cage nut. Be careful not to cross thread the bolt, and
leave loose until later steps.
5. Once the bar is in position, use the strap as a template to drill Ø1/8" holes. It may be necessary to pull back the door sealing gasket or
trim. Apply silicone or sealant around the hole, behind the strap. Secure the straps with the provided #10 stainless steel sheet metal
screws with washers as shown. Screws should be tightened around 5-10 in-lb.
6. Tighten the M6 bolts evenly so that the bar is even and centered. Reinstall any removed trim and/or weather-stripping and close doors
to check secure fit of the lightbar.
Mounting Instructions
12+ Series Lightbars
Page 1 of 2