Ecco Vantage 12+ Series Installation & Operation Instructions page 17

Basic Control Pad Mounting:
To mount the control pad with Velcro, separate the two circular
halves, remove the backing and adhere one piece on the ve-
hicle dashboard and adhere the other to the back of the control
pad. To mount the control pad using the swivel mount, first
mount the swivel unit to the dashboard with either the supplied
screws (note, the suction cup will not work after drilling screws
through the swivel base) or by turning the lever at the base of
the swivel unit to engage the suction cup. Push the control pad
onto the swivel slide and press the control pad down onto the
slide until it engages the slot in the control pad. (You may need
to turn the control pad clockwise once engaged with the slide to
tighten it.) Turn the dial on the swivel head to tighten it against
the back of the control pad. Finally, loosen the hand screw on
the swivel neck to adjust the angle of the control pad. Hold the
pad in the desired position while tightening the hand screw on
the swivel neck.
Advanced Control Pad Mounting:
The advanced control pad is supplied with three mounting op-
tions: a bracket, VHB tape and hook and loop patch. The rear
of the control pad is designed to allow for the cable exit to be
routed five different ways to maximize installation locations.
Mount the control pad in a location within convenient reach of
the operator so that s/he can operate the system without losing
eye contact with the roadway.
Push the controller onto swivel slide and press
the control pad down onto the slide until it
engages the slot in the control pad.
BRACKET
HOOK AND LOOP
PATCH
TAPE