Removing The M.2 2230 Solid-State Drive - Dell P104F Service Manual

c. Align the screw holes on the solid-state drive bracket with the screw holes on the system board.
d. Replace the two (M2x3) screws to secure the solid-state drive bracket to the system board.
Next steps
1. Install the base cover.
2. Install the microSD card.
3. Install the SIM card.
4. Follow the procedure in

Removing the M.2 2230 solid-state drive

Prerequisites
1. Follow the procedure in
2. Remove the SIM card.
3. Remove the microSD
4. Remove the base cover.
About this task
NOTE: You can refer the below procedure to remove the M.2 2230 solid-state drive from SLOT 1 and SLOT 2.
NOTE: SLOT1 supports only PCIe Gen4 Solid-state drive and does not support any Intel Optane.
NOTE: SLOT2 supports only PCIe Gen3 Solid-state drive and Intel Optane.
The following images indicate the location of the M.2 2230 solid-state drive and provide a visual representation of the removal
procedure.
Figure 5. M.2 2230 solid-state drive without bracket
after working inside your
before working inside your
card.
computer.
computer.
Removing and installing components 31