Display Bezel; Removing The Display Bezel - Dell P104F Service Manual

Steps
1. Place the display assembly on the computer, and align the screw holes on the display hinges with screw holes on the system
board.
2. Replace the six (M2.5x5) screws to secure the display hinges to the system board.
3. Close the display.
4. Connect the sensor-board cable to the connector on the system board and adhere the tape to secure the cable to the
system board.
5. Route the display and eDP cable through the routing guide on the system board.
6. Connect the eDP cable to the connector on the system board.
7. Connect the display cable to the connector on the system board.
8. Adhere the tape that secures the display cable to the system board.
9. Align the screw holes on the eDP cable bracket with the screw holes on the system board.
10. Replace the two screws (M2x3) that secure the eDP cable bracket to the system board.
11. Route the antenna cables through the routing guide.
Next steps
1. Install the WWAN card.
2. Install the WLAN card.
3. Install the base cover.
4. Install the microSD card.
5. Install the SIM card.
6. Follow the procedure in

Display bezel

Removing the display bezel

Prerequisites
1. Follow the procedure in
2. Remove the SIM card.
3. Remove the microSD
4. Remove the base cover.
5. Remove the display assembly.
after working inside your
before working inside your
card.
computer.
computer.
Removing and installing components 83