Installing The Memory Module; M.2 Solid-State Drive; Removing The M.2 2230 Solid-State Drive - Dell NOT22857 Owner's Manual

Installing the memory module

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the memory module and provide a visual representation of the installation
procedure.
Steps
1. Align the notch on the memory module with the tab on the memory-module slot on the system board.
2. Slide the memory module firmly into the memory-module slot at an angle.
3. Press down on the memory module to snap it on the system board. Ensure that the memory-module retention clips have
locked the memory module.
NOTE: If you do not hear the click, remove the memory module and reinstall it.
4. Repeat steps 1, 2 and 3 to install the second memory module, if applicable.
Next steps
1. Install the base cover.
2. Follow the procedure in

M.2 solid-state drive

Removing the M.2 2230 solid-state drive

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
After working inside your
Before working inside your
computer.
computer.
Removing and installing Customer Replaceable Units (CRUs) 43