Advertisement
After each session is completed, spray acrylic with a specially formulated UVT (ultra-violet transmit-
ting) acrylic cleaner. Wipe the acrylic with a clean cloth. The acrylic should never be wiped with a
dry cloth because this will generate a slight static charge which will attract dust. A mild liquid deter-
gent and water solution can be used temporarily in place of acrylic cleaner.
For maximum efficiency of your 164/4 Encore Tanning Bed, periodic cleaning of lamps is required.
Refer to relamping instructions for acrylic removal.
CAUTION: Do not use excessive amounts of water, any abrasive cleaners, or any spray cleaner that
carry label warnings regarding reactions to contact with skin!
ELECTRICAL SAFETY: The tanning unit should be disconnected from the power supply before
1. Disconnect power from unit.
2. Remove acrylic strips and slide acrylic out of the unit.
3. Turn the bi-pin lamp 90 degrees and remove from lampholder.
4. Align the bi-pin lamp and slide the top and bottom into the lampholder turn 90 degrees.
5. Clean and replace acrylic. (Refer: care and cleaning instructions.)
6. Reconnect unit to power.
CAUTION
Replacement lamps must comply with CFR 21 1040.20
When ordering lamps, include model number and serial number.
Replace only with Rave 160 APR 160W lamps, Rave 180 APR 180W lamps and
Heraeus OHC 560 500W for Facials.
* Please note - when removing canopy acrylic from these units - requirement is 2 people are
required, 1 person at each end of bed for ease of removal and installation.
www.heartlandtan.com
CARE AND CLEANING OF YOUR ENCORE BED
DO NOT USE ALCOHOL
cleaning or any repairs are made! Avoid water or solution entering the lamp
compartment.
ENCORE RELAMPING INSTRUCTIONS
9
11/05
Advertisement
