Advertisement
Cool down mode is the time the bed needs to cool down after a session has ended.
Cool down mode is the time the bed needs to cool down after a session has ended.
The Factory default setting is 3 minutes.
The Factory default setting is 3 minutes.
1. Connect the wires that control the fans to the headers on the back of the Heartland timer.
1. Connect the wires that control the fans to the headers on the back of the Heartland timer.
2. Set parameter 13 to the desired cool down time.
2. Set parameter 13 to the desired cool down time.
After a session has ended the display will show a single period in the middle of the display.
The period will remain until the
cool down time has elapsed. The display will then show a 0.
Note: If both cool down time and clean room are enabled, the clean room will be displayed.
If the clean room indication is cleared before the cool down time has expired, the cool
down indication will be displayed. If the cool down time has elapsed
before the clean room indication has been cleared , the clean room indication will remain
until it is cleared.
Figure A - Front View Of The Heartland Timer
Figure A - Front View Of The Heartland Timer
Note: D6
Note: D6 - Run and communications indication lights. Will flash at a once per second rate
- Run and communications indication lights. Will flash at a once per second rate
when operating a stand alone mode. When flashing
rapidly the communications are active (either with a T-Max
rapidly the communications are active (either with a T-Max
Manager or Master T-Max
Manager or Master T-Max
D5 - Power indication.
Figure B - Power Board Location
Figure B - Power Board Location
www.heartlandtan.com
Cool down mode
Cool down mode
Display Board Front View
3A). Will stay on solid if timer is in TPI mode.
3A). Will stay on solid if timer is in TPI mode.
®
T-Max Remote
or T-Max
Manager/
Plus/Pro
17
12' modular
cable to
power
board
®
Note: For timer loca-
tion see speci-
fications - wir-
ing diagram
ballast box for
your model.
11/05
Advertisement
