Table 2 : Hga-6000 Electrical Interface; Table 3 : Standard Hga-6000 Data And Power Cable Connectors - COBHAM HGA-6000 Installation Manual

HGA-6000 High Gain Antenna
Installation Manual
3.2.3.2 HGA-6000 to SDU Interconnection
Connecting the antenna to the SDU using the Modem Interface is done via a single coaxial cable.
Details are not given in this manual for this option, please contact Cobham for further details in this
regard.
3.2.3.2.1 Wiring Table
A 9-pin D-Type Female Connector may be installed at an accessible location for antenna
maintenance, if required.
SIGNAL
+28V_DC IN
28V_RET
A429_Tx_A Out
GND
A429_Tx_B Out
A429_Rx_A IN
GND
A429_Rx_B IN
GND
DLNA_BITE
DLNA_CTL
GND
RS232_RxD
RS232_TxD
3.2.3.2.2 Connector Types

Table 3 : Standard HGA-6000 Data and power cable connectors

NAME CONNECTOR
J2 MS3476W16-26P
MS3471W16-26S
Connector J2 may be changed to be customer specific.
Document: 862-A0059_IM issue 1.7

Table 2 : HGA-6000 Electrical Interface

J2 DESCRIPTION
Y Aircraft power
S Grounded to case internally
G ARINC 429 from antenna
M Screen for ARINC 429
H ARINC 429 from antenna
A ARINC 429 to antenna
M Screen for ARINC 429
B ARINC 429 to antenna
R Screen for DLNA signals
L DLNA BITE
K DLNA on/off control from antenna
F Serial data ground (to D-type pin 5)
D Serial data to antenna (to D-type pin 3)
E Serial data from antenna (to D-type pin 2)
DESCRIPTION
Pigtail Connector
Mating connector to Pigtail
COMPANY CONFIDENTIAL
Page 16 of 37