AIR-EAGLE
2.4 GHz RF Transmitter
MODEL 36-1400-AC
DESCRIPTION
The A
-E
SR PLUS TX is an R.F. transmitter capable of sending
IR
AGLE
four independent dry contact input commands to an Air-Eagle SR
Receiver from up to 600 feet away. Any number of transmitters and
receivers can be combined to create a medium-range remote control
system that operates hazardous or hard-to-reach electrical apparatus
from safe, convenient locations. This unit has eight user-selectable
network frequencies to allow multiple systems to operate
simultaneously in the same area without interference.
APPROVALS
United States (FCC)
Canada (IC)
Europe (CE)
INSTALLATION
Mount the A
-E
SR PLUS TRANSMITTER in a convenient
1.
IR
AGLE
location.
Install wiring to contact input terminal strip (Note – the terminal block
2.
header lifts off the base for easy wiring)
3.
Attach supplied antenna to connector on right side of unit.
4.
Connect supplied power input cable to your external power source.
TERMINAL STRIP WIRING
Wire as shown based on number of contact inputs
1
2
3
4
5
GENERAL OPERATION
A closure on any input transmits its channel command to activate the
corresponding relay in the remote receiver. The transmission continues as
long as the input is closed and ceases when the input opens.
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
®
SR PLUS
MCQ-XBEE3
1846A-XBEE3
ETSI
6
7
8
9
PRODUCT INFORMATION
Dimensions (with mounting plate) 6.3" L x 4.8" W x 2.3" H
CONTROLS & INDICATORS
10
TX LED
Dry Contact Inputs
SEL1
SEL2
BULLETIN
Illuminates green when power is applied.
Changes to red while any contact input is
closed and unit is transmitting.
Transmits individual RF codes to the receiver
Dip switch bank for frequency selection
Dip switch bank for digital address selection