AIR-EAGLE
2.4 GHz RF Transmitter
MODEL 36-10100-DCI-DC
DESCRIPTION
The A
-E
SR PLUS TX
s an R.F. transmitter capable of sending
IR
AGLE
I
a single 5-24VDC input command to an Air-Eagle SR Receiver located
up to 600 feet away. Any number of transmitters and receivers can be
combined to create a medium range radio frequency system that
operates hazardous or hard-to-reach electrical apparatus from safe,
convenient locations. Eight user-selectable frequencies allow multiple
systems to operate simultaneously in the same area without
interference.
APPROVALS
United States (FCC)
Canada (IC)
Europe (CE)
INSTALLATION
DISCONNECT DC Power from all equipment before installation.
1.
Mount the A
-E
SR T
IR
AGLE
2.
Install wiring to input terminal strip
3.
Install antenna. The unit has an antenna connector located on the
right side on the enclosure. Attach the supplied portable antenna to
this connector.
4.
Connect DC power to the proper terminals in your control circuit.
TERMINAL STRIP WIRING
TER 3
TER 2
VOLTAGE INPUT
RELAY OUTPUT
1
DC common
1
Not Used
2
+5-24VDC
2
Not Used
3
Not Used
GENERAL OPERATION
When 5-24VDC appears on the input the unit transmits to energize relay 1
(or another relay as selected by the channel code transmitted) in any
receiver within transmit range. The signal transmits continuously as long
5-24VDC is present and ceases when 5-24VDC is removed.
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
SR PLUS
®
OUR-XBEEPRO
4214A-XBEEPRO
ETSI
in a convenient location.
RANSMITTER
TER 1
AC/DC POWER INPUT
1
(-) 9-36VDC
2
(+) 9-36VDC
3
Not Used
PRODUCT INFORMATION
BULLETIN
Dimensions (with mounting plate) 7.07L x 3.57W x 1.62H
CONTROLS AND INDICATORS
Power – LED1
Illuminates green when unit is powered
TX – LED2
Illuminates red when unit is transmitting
Relay – LED3
Not used on this model
RF module that sends data to the remote
RF1
receiver
Seven dip switches for selecting options and
SEL1
network frequency
TER3
Voltage input
TER2
Relay output
TER1
Power Input