BWI Eagle AIR-EAGLE SR PLUS Product Information Bulletin

AIR-EAGLE
2.4GHz RF Transmitter
MODEL 36REB-1500
DESCRIPTION
The A -E SR PLUS TX s a handheld R.F. transmitter designed to
IR AGLE I
send a single STOP command to the Air-Eagle SR Receiver, Model
38P-2-ESTOP from up to 600 feet away. When powered on, this
transmitter begins sending a heartbeat "beacon" signal to the receiver
which keeps the receivers relays in an energized state, thus providing
a failsafe link. The receiver's relays will de-energize when the STOP
button is depressed OR if the link to the transmitter is lost. To save
battery life, this transmitter incorporates an On/Off procedure. Eight
user programmable frequencies allow multiple systems to be used
simultaneously in the same area.
INITIAL SET-UP
This transmitter comes ready to operate, with rechargeable batteries
installed, and factory programmed to Frequency #1. No setup is
necessary. The following steps must be followed to turn system on or off.
Turn System On:
Step #1 – Depress and hold Button 1/9 until the TX LED turns GREEN –
approximately 3 seconds.
Step #2 – Release Button 1/9. The TX LED will extinguish momentarily,
then begin to provide the battery charge status (BATTERY CHARGE
STATUS chart).
Step #3 – Once battery charge status has concluded, the TX LED will
begin to blink RED a few times a second to show the operator the unit is
powered up and transmitting a beacon signal.
Turn System Off:
Step #1 – Depress Button 1/9 until the TX LED turns RED - approximately
three seconds.
Step #2 - Release Button 1/9. The TX LED will extinguish momentarily,
then begin to provide the battery charge status (see chart).
Step #3 – Once battery charge status has concluded, the TX LED will
extinguish and the transmitter is now powered off.
BATTERY CHARGE STATUS
Full TX LED gives 3 GREEN blinks
Good TX LED gives 2 GREEN blinks
Low TX LED gives 2 RED blinks
Charging Required TX LED gives 10 rapid RED blinks
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
®
SR PLUS
PRODUCT INFORMATION
BULLETIN
Dimensions – 5.36" L x 2.92" W x .1.26/1/04' D
(note: STOP button adds .73" to length)
CONTROLS & INDICATORS
Illuminates RED continuously while E-Stop
button is depressed and unit is transmitting.
Also guides user through On/Off Procedure and
TX LED
provides battery charge status (See INITIAL
SET-UP & BATTERY CHARGE STATUS
sections)
Transmits STOP command to the receiver
E-Stop Button
Powers TX On/Off – No other function
Pushbutton1/9
Pushbuttons 2/10
Not used on this model
thru 8/16
Puts TX in frequency programming mode (See
Pushbutton P/Shift
PROGRAMMING section