BWI Eagle AIR-EAGLE SR PLUS Product Information Bulletin

AIR-EAGLE
2.4 GHz RF Repeater
MODEL 36-4500-DC
DESCRIPTION
The A -E SR PLUS RF R
IR AGLE
RF signal from any Air-Eagle SR or SR PLUS Transmitter. When
placed in an area where the signal is weak, this unit will then re-
transmit at full strength facilitating greater distances and allowing the
RF signal to reach around corners, through tunnels, over hills and
through valleys.
APPROVALS
United States (FCC)
Canada (IC)
Europe (CE)
INSTALLATION
DISCONNECT Power from all equipment before installation.
Mount the A -E XLT REPEATER in a convenient location.
IR AGLE
1.
2. Attach rubber duck antenna or coax from external antenna to
connector on side of enclosure.
3. Connect supplied power input cable to your external power source.
TERMINAL STRIP WIRING
TERMINAL STRIP WIRING (TER1)
Terminal 1 (-) 9-36VDC INPUT
Terminal 2
(+) 9-36VDC INPUT
Terminal 3 Not Used
Terminal 4 Not Used
Terminal 5 Not Used
Terminal 6 Not Used
Terminal 7 Not Used
Terminal 8 Not Used
Terminal 9 Not Used
Terminal 10 Not Used
Terminal 11 Not Used
Terminal 12 Not Used
Terminal 13 Not Used
Terminal 14 Not Used
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
®
SR PLUS
designed to retransmit an
EPEATER IS
MCQ-XBEE3
1846A-XBEE3
ETSI
PRODUCT INFORMATION
BULLETIN
CONTROLS & INDICATORS
RX LED
POWER LED
TX LED
RF1
SEL1
Yellow LED illuminates as remote signals are
being received by the repeater
Green LED is illuminated while power is
applied to the repeater
Red LED illuminates as remote signals are
being re-transmitted by the repeater
RF module that receives data from the remote
transmitter
Used to set frequency
.