Download Print this page
BWI Eagle AIR-EAGLE SR PLUS 36-HH-4 Manual

BWI Eagle AIR-EAGLE SR PLUS 36-HH-4 Manual

2.4 ghz rf transmitter

Advertisement

Quick Links

AIR-EAGLE SR PLUS
36-HH-4
2.4 GHz RF Transmitter
Document Date: 6/21/2021
Product Rev: 12

Advertisement

loading

Summary of Contents for BWI Eagle AIR-EAGLE SR PLUS 36-HH-4

  • Page 1 AIR-EAGLE SR PLUS 36-HH-4 2.4 GHz RF Transmitter Document Date: 6/21/2021 Product Rev: 12...
  • Page 2: Warranty Statement

    36-HH-4 WARRANTY STATEMENT BWI Eagle Inc. warrants the Air-Eagle Remote Control System, if properly used and installed, will be free from defects in material and workmanship for a period of 1 year after date of purchase. Said warranty to include the repair or replacement of defective equipment. This warranty does not cover damage due to external causes, including accident, problems with electrical power, usage not in accordance with product instructions, misuse, neglect, alteration, repair, improper installation, or improper testing.
  • Page 3: Controls And Indicators

    36-HH-4 Dimensions – 4.25” L x 2.68” W x .91” D (note: belt clip adds .43” to depth) INTRODUCTION The Air-Eagle SR PLUS TX is a handheld R.F. transmitter capable of sending up to four unique digital commands to an Air-Eagle SR Receiver located up to 600 feet away. Any number of transmitters and receivers can be combined to create a medium-range radio frequency system that operates hazardous or hard-to-reach equipment from safe, convenient locations.
  • Page 4: Frequency Programming

    36-HH-4 FREQUENCY PROGRAMMING Please read through these instructions completely before beginning programming procedure! At any time, you can check the current frequency setting by depressing Buttons 3 & 4 simultaneously, for approximately 5 seconds, until the TX LED is illuminated RED. Then release the buttons and watch as the TX LED stays RED for about 8 seconds, goes out, then begins to blink.
  • Page 5 36-HH-4 POWER LEVEL PROGRAMMING Please read through these instructions completely before beginning programming procedure! All transmitters are set to Power Level 4 (max range 600 ft) default. The power level can be changed at any time by following the procedure below. Power level settings will not be changed during normal battery replacement.
  • Page 6: Specifications

    36-HH-4 SPECIFICATIONS Durable Sealed Membrane Keypad – Eliminates Dust, Dirt and Keypad Moisture Failures Enclosure ABS UL94 HB Enclosure with ring is rated IP54 *Not Protective Ring SEBS (TPE) Waterproof Power Requirements 3.0 VDC (2) 1.5V lithium each, size AAA, to equal 3.0VDC nominal. Battery Type ***For best performance use ONLY Energizer Brand Lithium Batteries...

This manual is also suitable for:

Air-eagle sr plus36-hh-4