36U-HHEBD-4 WARRANTY STATEMENT BWI Eagle Inc. warrants the Air-Eagle Remote Control System, if properly used and installed, will be free from defects in material and workmanship for a period of 1 year after date of purchase. Said warranty to include the repair or replacement of defective equipment. This warranty does not cover damage due to external causes, including accident, problems with electrical power, usage not in accordance with product instructions, misuse, neglect, alteration, repair, improper installation, or improper testing.
Page 3
Photo on right shows unit with optional mounting plate INTRODUCTION The Air-Eagle SR PLUS TX is a handheld R.F. transmitter capable of operating the relays of an Air-Eagle SR Receiver located up to 600 feet away. Eight user-programmable frequencies allow multiple systems to operate simultaneously in the same area without interference.
36U-HHEBD-4 CONTROLS & INDICATORS While transmitting a beacon the display will rotate a character around the outside of the screen to show that it’s transmitting. The character will be as follows: Battery is discharging TX Display Battery is charging Battery is discharging, Level is below 10% (LOW BATTERY) POWERED ON Battery is charging, Level is 100%...
36U-HHEBD-4 MENU SETTINGS Prior to initial use, the transmitter must be programmed. The MENU button allows you to enter programming mode. It is important to follow the steps in the order shown below. Please read thru this section thoroughly before starting programming. Press the “MENU”...
36U-HHEBD-4 SYSTEM ON/OFF SYSTEM ON Depress and hold the Power/Select button. The display will show 3….2….1… then “Power On” when the unit has turned on. Release the Power/Select button and the unit will begin to transmit a beacon signal to the receiver approximately every 0.5 seconds NOTE: If a receiver hasn’t been paired, the display will show “SR+ Not Paired”.
36U-HHEBD-4 CHARGING Use only the micro-USB cable to connect to USB supply rated at 5V and at least 1 amp of current. When the charger is plugged into the jack the display will show “Charging” and the current battery level in %. When pressing the power/select button normally it shows the battery level with BAT: over top of it.
Page 8
36U-HHEBD-4 DIMENSIONS Standard Model Model with Optional Mounting Plate...