AIR-EAGLE
2.4 GHz RF Transmitter
MODEL 36-1200-BAT
DESCRIPTION
The A
-E
SR PLUS,
IR
AGLE
MODEL
designed to send a single stop command to any Air-Eagle SR Receiver
from up to 600 feet away. Any number of transmitters and receivers
can be combined to create a remote control system. This unit has eight
network frequencies and sixteen digital addresses to allow multiple
systems to operate simultaneously in the same area without
interference.
APPROVALS
United States (FCC)
Canada (IC)
Europe (CE)
INSTALLATION
1.
Mount the A
-E
SR PLUS TRANSMITTER in a convenient
IR
AGLE
location where the operator will have easy access to the stop button.
2.
Install Ch. 2-4 wiring to contact input terminal strip if desired.
3.
Install the two AA lithium batteries that were provided.
4.
Install antenna onto connector on the right side of the enclosure.
TERMINAL STRIP WIRING
Wire as shown based on number of contact inputs
1
2
3
4
105 Bonnie Drive
Butler, PA 16002
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
®
SR PLUS
36-1200-BAT is an R.F. transmitter
OUR-XBEEPRO
4214A-XBEEPRO
ETSI
5
6
7
8
9
PRODUCT INFORMATION
Dimensions (with mounting plate) 6.3" L x 4.8" W x 4.3" H
CONTROLS & INDICATORS
10
TX LED
Dry Contact Inputs
SEL2
SEL1
BULLETIN
Illuminates red while booting up, then
extinguishes.Illuminates red while any contact
input is closed and unit is transmitting. When
this LED blinks briefly following a
transmission, the battery needs to be
replaced.
Transmits individual RF codes to the receiver
Dip switch bank for digital address selection
Dip switch bank for frequency selection