Communication With Pc - ITech IT8500+ Series Manual

interface, you can use the communication module IT-E123 and an a standard
RS485-RS232 conversion cable to connect the DB9 interface connector of
the DC load and the RS-232 interface connector of computer for the
communication.

1.2 Communication with PC

Before using the remote operation mode, please make sure that the baud rate
and communication address in the DC load are the same as in the computer
software, otherwise, the communication will fail, you can change the baud
rate and communication address from the front panel or from computer.
DB9 Serial Port
In order for the computer to communicate with the DC load, both must be set
to the same RS-232 settings. These communication settings are:
1.
2.
3.
4.
5.
RS485 pins
Baud rate: 4800,9600,19200 and 38400 are selectable, default setting is
9600.
Data bit: 8 bit
Stop bit: 1
Parity: None
Address: the range is from 0 to 31, default setting is 0
Start Bit 8 Data Bits Parity=None
7
Stop Bit