User manual
5.)
Take the drive bearing out of the box. Please remove the bearing protection film carefully and apply
2-3 drops of the bearing oil (provided, and also available at
).
www.analogshop.de
Carefully place the bearing onto the bearing axis.
Pic. 6:
Pic. 7:
Setup of the bearing
Setup of the bearing
6.)
Remove the protection film from the sensor mounted on the turntable chassis.
Please do so extremely carefully to avoid introducing any dirt or scratches.
Carefully take the stainless steel platter out of the box, using both hands. Remove the protection
film from the scale ring on the lower side of the turntable. The lower platter side with the scale ring
must be face down when placing it on the bearing.
Again, please remove the lamination extremely carefully to avoid introducing any dirt
or scratches.
Pic. 8:
Montage of the sub-platter with the scale ring
Made in Germany
Page 11