Device Configuration - Omron SYSMAC NJ Series Network Connection Manual

5.2. Device Configuration

The hardware components to replicate the connection procedures in this guide are as follows:
PC (Sysmac Studio,
HMS IPconfig and
Anybus Configuration
Manager - X-gateway
installed,
OS: Windows 10)
LAN cable
USB cable
Manufacturer
OMRON NX-series CPU Unit
(built-in EtherNet/IP port)
OMRON Switching hub
OMRON Sysmac Studio
PC (OS: Windows 10)
－
LAN cable
－
(STP (shielded, twisted-pair) cable of
Ethernet category 5 or higher)
Anybus X-gateway EtherCAT Slave -
HMS
EtherNet/IP Adapter
HMS EDS file
HMS HMS IPconfig
Anybus Configuration Manager - X-
HMS
gateway
USB cable
HMS
(USB 2.0-compliant, B connector)
Power supply (24 VDC for Controller)
－
Power supply
－
(24 VDC for switching hub)
Power supply (24 VDC for X-gateway)
－
Precautions for Correct Use
Contact HMS INDUSTRIAL NETWORKS AB to obtain the EDS file specified above before
proceeding.
Precautions for Correct Use
Update Sysmac Studio to the version 1.43 or to a higher version. If you use a version higher
than the one specified, the procedures and related screenshots described in Section 7 and
the subsequent sections may not be applicable. In that case, use the equivalent procedures
described in this guide by referring to the Sysmac Studio Version 1 Operation Manual (Cat.
No. W504).
5．Applicable Devices and Device Configuration
NX102-1200
(built-in EtherNet/IP port 1)
Power supply
LAN cable
LAN cable
W4S1-05C
Power supply
Name
X-gateway
Model
NX102-1200
W4S1-05C
SYSMAC-SE2□□□
－
－
AB7682
005A000C004B0300.eds
－
－
(supplied with X-gateway)
－
－
－
Power supply
Version
Ver.1.42
Ver.1.0
Ver.1.43
Ver.3.29
Ver.1.7
Ver.4.2.0.0
Ver.1.5.1.1
6