Lexmark CX532 User Manual page 38

Set up, install, and configure
CAUTION—POTENTIAL INJURY: To reduce the risk of fire, use only a 26 AWG or larger
telecommunications (RJ-11) cord when connecting this product to the public switched telephone
network. For users in Australia, the cord must be approved by the Australian Communications and Media
Authority.
The standard wall jack adopted by most countries or regions is RJ‑11. If the wall jack or equipment in your facility
is not compatible with this type of connection, then use a telephone adapter. An adapter for your country or
region may not come with your printer, and you may need to purchase it separately.
There may be an adapter plug installed in the telephone port of the printer. Do not remove the adapter plug
from the telephone port of the printer if you are connecting to a serial or cascaded telephone system.
Part name
Lexmark adapter plug
Connecting the printer to a non‑RJ‑11 wall jack
1
Connect one end of the telephone cable to the line port of the printer.
2
Connect the other end of the cable to the RJ‑11 adapter, and then connect the adapter to the wall jack.
3
If you want to connect another device with a non‑RJ‑11 connector to the same wall jack, then connect it
directly to the telephone adapter.
Part number
40X8519
38