POWER ON
Turn the Power switch/ Volume control clockwise to switch the
transceiver power ON.
•
Beep A (1 beep) will sounds and the display momentarily
lights up.
ADJUST THE VOLUME
Rotate the Power switch/ Volume control to adjust the volume.
•
Clockwise increases the volume and counterclockwise
decreases the volume.
If you are not receiving a signal, press the Side 1 button
•
to unmute the speaker, then adjust the volume control to a
comfortable audio output level.
SELECT A CHANNEL
Rotate the Selector to select your desired channel.
Press the Side1 button to check whether or not the channel
•
is free before making a call.
MAKE A CALL
Press and hold the PTT switch, then speak into the microphone
using your normal speaking voice.
•
The LED lights in red.
•
Hold the transceiver approximately 3 to 4 cm (1.5 inches)
from your mouth.
Release the PTT switch to receive.
Note:
◆ When the battery pack voltage becomes too low, transmission will stop and an
alert tone will sound.
BASIC OPERATION
10