Sanyo VCC-HD4600P User Manual page 19

1
Use the / button to select [NETWORK SET] on the menu screen, and press the SET
button.
The network configuration screen appears.
2
Select [DHCP] using the
The symbol appears beside the available option, and you are ready to configure it.
3
Use the / button to select "ON" or "OFF" for [DHCP], and press the SET button.
The setting is saved and the
OFF: Sets the IP address manually (Go to step
ON: Enables automatic address configuration using DHCP. (Go to step
Setting [DHCP] to "ON" causes the menu items [IP ADDRESS], [SUBNET MASK], and [GATEWAY]
to disappear.
4
Select [IP ADDRESS] using the
The IP ADDRESS screen appears.
5
Move the cursor to the desired position using the
digit using the
The configured address setting is saved and you return to the network configuration screen.
6
In the same way as you did in [IP ADDRESS] (step
[SUBNET MASK] and [GATEWAY].
7
Select [PORT] using the
The PORT screen appears.
When [SSL] is set to "ON" on the NETWORK SETTINGS screen, the screen title appears as [PORT
(SSL)].
8
Move the cursor to the desired position using the
digit using the
The configured port number is saved and you return to the network configuration screen.
/ button and press the SET button.
symbol disappears.
/ button and press the SET button.
/ button, and then press the SET button.
/ button and press the SET button.
/ button, and then press the SET button.
4
.)
7
/ button, select a number in each
to ), configure the settings in
4 5
/ button, select a number in each
.)
Introduction 19/23