Sanyo VCC-HD4600P User Manual page 151

The camera does not record.
1 A recording medium is not inserted or installed in the camera.
Insert an SD memory card or install an external hard disk drive on the camera.
2 The recording medium is not formatted.
Go to the SD/HDD screen, and format the recording medium.
3
Time elapsed from turning on the camera is less than 5 minutes.
The system cannot recognize a recording medium for about 30 seconds after powered on.
After turning on the camera, wait 5 minutes or more before starting to record.
4
The recording medium is write-protected.
Cancel the protection in order to allow the recording medium for writing.
5
The USB cable for the hard disk drive is not connected properly.
Turn off the HDD drive, re-insert the USB cable correctly and turn on the HDD drive again.
6 An installed recording medium was removed before writing was stopped.
Format the recording medium. If you remove a recording medium while writing is in progress, you
may damage it. Be sure to perform the following procedure to stop a writing operation before you
remove the medium.
<Method for stop recording>
In [SD MEMORY CARD] or [HDD] on the SD/HDD screen, select "NO USE".
Or press the and SET buttons on the side face of the camera simultaneously.
I cannot play back.
The camera is not equipped with playback functions.
Install the supplied application software "HDC Downloader/ DLViewer" from the supplied CD-ROM.
This application software will allow you to download and play back video data.
Q&A 10/11