Sanyo VCC-HD4600P User Manual page 16

Connect a buzzer, lamp, or other alarm device to one of the alarm output terminals (ALARM OUT1 or 2).
After connecting an alarm device, configure the output conditions for the corresponding alarm output
terminal (ALARM OUT1 or 2) via network operation on the ALARM SETTINGS screen.
Alarm output terminal configuration is also possible via remote operation.
Connect an alarm switch, infrared sensor, or other external device to one of the alarm input terminals (ALARM IN1
or 2).
After connecting an alarm device, configure the input conditions for the corresponding alarm input
terminal (ALARM IN1 or 2) via network operation on the ALARM SETTINGS screen.
To use the alarm input terminals as Day/Night switching terminals, follow the steps below.
Under [DAY/NIGHT], set [DAY/NIGHT] to "COLOR" and select the terminal you want to use in
[EXT ALARM].
On the ALARM SETTINGS screen, in [POLARITY], select the signal polarity of the alarm input
terminal.
Introduction 16/23