Technika GHEO9TD Operating And Installation Instructions page 26

REPLACING THE TAPS (mod GHEO6TD)
To change a tap proceed as follows (fi g. 24):
• Remove pan supports, burner heads and knobs.
• Unscrew the burners securing screws.
• Remove the lateral sides, lid and hob.
• Unscrew the check nuts of rails (D) and/or of any
thermocouples and remove tap (R) or the thermostat
(T) by unscrewing the screws (V).
• Partly remove the burners small supply pipes and
change the relative part.
• Replace the seal (G) each time you change a tap so
as to guarantee a perfect fi t between body and rail.
• Reassemble all the parts following the same
procedure but in the reverse order.
CHANGING THE FLEXIBLE GAS HOSE
In order to guarantee that the gas hose is always in
excellent condition we strongly recommend changing
it on the date you will fi nd printed on it.
V
G
D
T
6. INSTRUCTIONS FOR THE INSTALLER
G
R
24
REPLACING THE ELECTRICAL COMPONENTS
(mod GHEO9TD)
• The rear protection will have to be removed in order
to change the electrical heating elements, spit
motor, terminal board and power cable.
• If you have to change the power cable (see the
cross section on table on page 29), always keep
the earth wire longer than the phase wires and,
in addition, follow all the instructions given in
the "ELECTRICAL CONNECTION" paragraph.
• To change the oven lamp see the instructions on
page 16.
• To change the lamp holder, the spark generator
and the spark electrodes, the work top has to be
removed as indicated in the previous paragraph.
• To change the lamp-holder (fi g. 10b), unscrew the
protective glass cap (C), force the tabs of blockage
and take the lamp-holder toward the inside of the
oven.
• To change the programming accessory, thermostat,
the commutator and the warning lights, remove the
front panel as indicated in the previous paragraph.
REPLACING THE ELECTRICAL COMPONENTS
(mod GHEO6TD)
• The rear protection will have to be removed in order
to change the electrical heating elements, lamp
holder, terminal board and power cable.
• If you have to change the power cable (see the
cross section on table on page 28), always keep
the earth wire longer than the phase wires and,
in addition, follow all the instructions given in
the "ELECTRICAL CONNECTION" paragraph.
• To change the oven lamp see the instructions on
page 16.
• To change lamp holder (P) (fi g. 10a), use a
screwdriver to push the clamp tips (M) (fi g. 21) and
pull the lamp holder out towards the inside of the
oven.
• To change the thermostat or switches the hob top has
to be removed.
26