Table of Contents
Advertisement
RJ45 Cable Pinouts
Bundle PID
CABLE-16TDM-R3EL2
CABLE-16TDM-R3EL3
RJ45 Cable Pinouts
T1 lines from individual subscribers are attached to RJ45 connectors on the front of the 24-port patch panel.
Each RJ45 port accommodates an individual T1 subscriber line.
For the T1/E1 ports, see the
Installing Patch Panel
To install the brackets on the rear of the patch panel, perform these steps:
Step 1
Remove the larger (M4) rack mount screws (as indicated in the Rack Mount Screws figure below) from both sides. To
secure the brackets, follow the instructions in Step-3.
Step 2
Remove the patch panel rack-mount brackets from the accessory kit and position them beside the patch panel.
Step 3
Position the brackets against the patch panel sides, and align with the screw holes. Secure the rack mount bracket to patch
panel using a torque of 13.2 in.-lb (1.5 N-m) see the figure below.
Installing the Cisco NCS 4206
50
Cable Marking
T3/E3-Cable M-3
T3/E3-Cable M-2
T3/E3-Cable M-1
T3/E3-Cable L-3
T3/E3-Cable L-2
T3/E3-Cable L-1
T1/E1 Port
Pinout.
Installing the Cisco NCS 4206
Description
16-port cable for TDM CEM Interface Module,
62 inches cable length and 10 inches stub length,
even slot
16-port cable for TDM CEM Interface Module,
62 inches cable length and 7.5 inches stub length,
even slot
16-port cable for TDM CEM Interface Module,
62 inches cable length and 6.5 inches stub length,
even slot
16-port cable for TDM CEM Interface Module,
78 inches cable length and 10 inches stub length,
even slot
16-port cable for TDM CEM Interface Module,
78 inches cable length and 7.5 inches stub length,
even slot
16-port cable for TDM CEM Interface Module,
78 inches cable length and 6.5 inches stub length,
even slot
Advertisement
Table of Contents
