Cisco NCS 4206 Installing page 43

Installing the Cisco NCS 4206
Figure 30: Cisco NCS 4206 Flash Token Memory Stick
Removing a USB Flash Device
To remove and then replace a USB flash token memory stick from a Cisco NCS 4206, follow these steps:
Step 1 Pull the memory stick from the USB port.
Step 2
To replace a Cisco USB Flash memory stick, simply insert the module into the USB port labeled MEM. The Flash memory
module can be inserted in only one way, and can be inserted or removed regardless of whether the is powered up or not.
You can insert or remove the memory stick whether the is powered on or not.
Note
Connecting Timing Cables
Note
Connecting Cables to the BITS Port using the Wire Wrap Interface
The following steps describe how to connect cables to the BITS port using Wire wrap interface:
Procedure
Command or Action
Step 1
Connect the BITS port using a wire wrap adapter.
Step 2 Connect the wire wrap adapter to the RJ-45 port.
When installing the cabling to the RSPs, we recommend that you leave a service loop of extra cabling sufficient
to allow for fan tray removal.
Purpose
For information about the Wire wrap pinouts, see
Troubleshooting.
Installing the Cisco NCS 4206
Removing a USB Flash Device
43