Cisco NCS 4206 Installing page 3

Installing the Cisco NCS 4206
Installing the Chassis in the Rack
The procedures in this section apply to both horizontal and vertical mounting of the in a rack.
To install the chassis in the equipment rack, perform these steps:
Step 1
Position the chassis in the rack as follows:
• If the front of the chassis (front panel) is at the front of the rack, insert the rear of the chassis between the mounting
posts.
• If the rear of the chassis is at the front of the rack, insert the front of the chassis between the mounting posts.
Step 2
Guide the chassis carefully into the plenum assembly. See the figure below.
Figure 3: Installing the Chassis on a 19-inch Rack (A903-RCKMNT-19IN3)
Installing the Chassis in the Rack
Installing the Cisco NCS 4206
3