BRAVILOR BONAMAT FRESHONE (G) Operating Principle page 20

6. Boiler temperature:
D Set the maximum temperature for the water in the boiler.
6.1 Rerun the boil program:
D Set the water temperature to 0_C.
D Press the right button. This starts the calibration program again. The working temperature is
automatically set to 4_C below the boiling point.
7. Descaling signal:
D ontact your local water company to find out how hard your water is.
Always select the right setting. The machine's default setting is 3 (1000L). The machine continuously
records the time the intake valve is open and therefore the amount of water (in litres) that flows
through the system. When the amount of water recorded by the machine is higher than or equal to the
amount of water set in the software, the descaling pictogram will start blinking on the LCD.
Fig. 34 Descaling pictogram
8. Energy−saving mode:
D Minutes/hours after which the machine switches to ECO mode. All functions such as the boiler,
ventilation and display lighting switch off and the LCD displays [ECO]. The machine switches on again
when a selection button is pressed. Depending on the switch−off time, it can take a few minutes
before the machine is ready for use.
9. Waste bin full indicator:
D The FreshGround has an electronic counter that keeps track of the number of cycles the brewer has
completed and transported a cake of coffee to the waste bin. The waste bin is full when the
programmed number has been reached. The waste bin pictogram displays on the LCD and the
machine blocks. The machine is released when the waste bin has been emptied and the counter
reset. Press the button with the waste bin pictogram to reset the counter.
10. Coin mechanism:
D Activate this setting only if the machine has a coin system (optional) and you would like to use it.
Please note:
− Settings 11 to 16 are only available if the coin system has been activated (10).
− The price is set in the program menu (for coffee, see point 28; for drink−dependent, see point 36; for hot
water, see point 42).
11. Coin rejection/acceptance (0.05):
D Indicate whether the coin should be rejected (left button) or accepted (enter button).
12. Coin rejection/acceptance (0.10):
D See point 11.
13. Coin rejection/acceptance (0.20):
D See point 11.
16