Table of Contents
Advertisement
After approximately 20 minutes the wood logs burn. Dependent on the quality of the
chimney the wood logs burn for approximately 1 to 1.5 hours. Do not open the door of the
appliance before the last flames have almost disappeared.
7.3.2
Reload with fuel
1.
2.
3.
4.
5.
6.
7.
7.3.3
Control the burn process
Control the burn process with the control lever. This lever controls the amount of primary
combustion air and both the secondary combustion air and airwash amount.
Cuatro-7 75-60
Caution:
If there is insufficient burning material in the firebed to light a new fuel charge,
excessive smoke emission can occur. Refueling must be done onto a
sufficient quantity of glowing embers and ash to make sure that the new fuel
charge will ignite in a reasonable period. If there are too few embers in the fire
bed, add suitable kindling to prevent excessive smoke.
Note:
The procedure hereunder is a general description. The best reloading
moment is dependent on the flue draught. A high flue draught requires
reloading when the flames have completely disappeared. If the flue draught is
low, reloading must be done when there are still flames.
Wait until the last flames have almost disappeared.
Set the control lever in the far right position.
Open the door.
Reload the appliance with the
recommended amount of fuel. Refer
to section 6.2.1.
Close the door.
After ignition of the fuel, move the
control lever to a position that gives a
quiet burning fire.
If desired and applicable, start the
convection ventilator.
Note: If the appliance has the Opti-Air option refer to section
instructions on the control of the burn process.
Operation
7.4
for
19
Advertisement
Table of Contents
Troubleshooting
