Operation; Preparation Before First Use; First Use Of The Appliance; Firing The Appliance (Without Opti-Air) - barbas Cuatro-7 75-60 User Manual

7

Operation

7.1

Preparation before first use

Report any defects to your dealer immediately.
1.
2.
3.
4.
5.
6.
7.
8.
9.
7.2

First use of the appliance

Before first use make sure that a newly-build chimney breast is dry. Walls that have not
dried sufficiently attract particles released from your appliance when suddenly opening
the door of the appliance during use.
After first few times of use of the appliance, a light deposit on the inside of the glass may
occur caused by curing of the paint. This can be removed with glass cleaner or ceramic
hob cleaner.
7.3

Firing the appliance (without Opti-Air)

7.3.1

First load and ignition

At the beginning the appliance and chimney is cold. It is important that both the appliance
and chimney reach a temperature that guarantees a good functioning of the appliance. A
too low temperature results in incomplete combustion and a poor chimney draught. To
avoid this do the following:
Cuatro-7 75-60
Make sure that the appliance is not damaged.
Make sure that the glass is not damaged.
Make sure that the door opens and closes completely.
Remove document and components from the combustion chamber.
Make sure that the control lever moves easy. (Not applicable for appliances with the
Barbas Opti-Air system)
Make sure that the ash tray is empty.
Make sure that the ventilation and - if applicable - convection inlet and outlet
openings are open
Make sure that all package material, stickers, etc, have been removed from the
vicinity of the appliance after installation.
If applicable, download and install the Barbas Opti-Air app. Refer to section
detailed instructions.
Caution:
• Do not use the appliance for 4 weeks after installation. This time is
necessary for the building materials to set.
• Make sure there is sufficient ventilation in the room in which the appliance
is installed.
Note:
The appliance has a heat-resistant coating. When you use the appliance for
the first time, the coating can cause an unpleasant, but harmless smell.
Note: Refer to section 7.4 if the appliance has the Opti-Air system installed.
Operation
7.4.1 for
17